Ford Focus Service Manual: Bumper Cover - Front

Ford Focus Service Manual / Body / Body Exterior / Bumpers / Bumper Cover - Front

NOTE:

Sedan shown, coupe similar.

Item	Part Number	Description
1	N807389	Grille assembly pushpins
2	8200	Grille assembly
3	17D957	Front bumper cover
4	W709976	Lower air deflector screw (8 required)
5	W710752	Lower air deflector pushpins
6	8B407	Lower air deflector assembly
7	N807389	Front fender-to-bumper cover pushpin (6 required)
8	N807389	Front bumper cover mounting bracket-to-radiator support pushpin (2 required)
9	17D958 LH/ 17D959 RH	Front bumper cover mounting bracket
10	W710771	Front bumper cover mounting bracket nut (4 required)
11	W714665	Front fender bolt (2 required)
12	W704340	Upper bumper cover pushpins

Removal and Installation

NOTE:

The front bumper beam is a welded on component.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.

NOTE:
Sedan shown, coupe similar.
Remove the 4 radiator grille pin-type retainers and the radiator grille.

Remove the radiator lower air deflector. For additional information, refer to Section 501-02.

NOTE:
Sedan shown, coupe similar.
Remove the 6 fender splash shield pushpins.

Remove the fog lamp wiring harness pin-type retainer and position aside.

NOTE:
Sedan shown, coupe similar.
Remove the 2 upper bumper cover pin-type retainers.

NOTE:
LH sedan shown, RH and coupe similar.
NOTE:
The headlamp was removed for better view of pushpin.
Remove the 2 pushpin retainers from the bumper cover mounting reinforcement bracket located beneath the headlamps.

NOTE:
Sedan shown, coupe similar.
Remove the 4 bumper cover mounting reinforcement bracket nuts.

NOTE:
Sedan shown, coupe similar.
NOTE:
The rearward upper portion of the bumper cover must be pulled outward to release the bumper cover mounting reinforcement from the front LH and RH fender.
Remove the bumper cover.

NOTE:
Sedan shown, coupe similar.
Disengage the bumper cover from the retaining brackets and remove the bumper cover by peeling from the wheel well first.

To install, reverse the removal procedure.

Bumper - Rear

NOTE: Sedan shown, coupe similar. Item Part Number Description 1 W520413 Rear bumper nut (4 required) 2 17906 Rear bumper Removal a ...

Bumper Cover - Rear

NOTE: Sedan shown, coupe similar. Item Part Number Description 1 17D948 RH/ 17D949 LH Bumper cover brackets 2 17K835 Bumper cover assembly ...

More about Ford Focus:

Ford Focus Connecting Rod to Crankshaft Side Clearance
Special Tool(s) Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent NOTE: Refer to the appropriate Section 303-01 for the specification. Using the Feeler Gauge Set, measure the clearance between the connecting rod and the crankshaft. Verify the measurement ...