Ford Focus Service Manual: Roof Opening Panel Glass

Ford Focus Service Manual / Body / Roof - Fixed, Leisure / Roof Opening Panel Glass

Removal

NOTE:

The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system, including: whenever the roof opening panel motor has been removed from the roof opening panel system, the roof opening panel glass has been removed from the roof opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a new roof opening panel glass has been installed or a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization in this section.

Position the roof opening panel to the CLOSED position.

Remove the 4 roof opening panel glass screws.

Remove the roof opening panel glass.

Installation

NOTE:
Do not fully tighten the roof opening panel glass screws at this stage.
Position the roof opening panel glass and loosely install the 4 screws.

Align the roof opening panel glass. For additional information, refer to Roof Opening Panel Alignment in this section.

Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization in this section.

Roof Opening Panel - Removal and Installation

Removal NOTE: Make sure the roof opening panel is in the CLOSED position. Remove the headliner. For additional information, refer to Section 501-05. Disconnect the 2 front ...

Roof Opening Panel Shield

Removal and Installation NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system, including: whenever the roof opening pa ...

More about Ford Focus:

Ford Focus Muffler and Tailpipe
Removal NOTE: The production muffler and tailpipe assembly is one-piece construction. The service muffler and tailpipe is 3-piece construction for Partial Zero Emissions Vehicle (PZEV) and 2-piece construction for non-PZEV . It is necessary to cut the production exhaust system to enable the ...