Ford Focus manuals

Ford Focus Service Manual: Transmission Fluid Cooler Tubes

Ford Focus Service Manual / Powertrain / Transmission/Transaxle / Automatic / Transmission Fluid Cooler Tubes

Material
Item Specification
Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLV MERCON® LV

Transmission Fluid Cooler Tubes


 
Item Part Number Description
1 7J081 Transmission fluid cooler tube secondary latches
2 — Transmission fluid cooler tube latches (part of 7890 assembly)
3 7890A Transmission fluid cooler outlet tube
4 7890B Transmission fluid cooler inlet tube

Removal

  1. Remove the Air Cleaner (ACL) . For additional information, refer to Section  303-12.
  1. Remove the 4 transmission fluid cooler tube secondary latches from the transmission fluid cooler tubes.

  1. Disconnect the transmission fluid cooler tubes from the transaxle and the transmission fluid cooler and remove the transmission fluid cooler tubes.
    1. Compress the tabs on the transmission fluid cooler tube latches and slide the latch out of the transmission fluid cooler tube to unlock the transmission fluid cooler tube from the transaxle or transmission fluid cooler.
    1. Remove the transmission fluid cooler tubes.

Installation

  1. If the transmission fluid cooler tube latches are not in the unlocked position, compress the tabs on the transmission fluid cooler tube latches and slide the latch out of the transmission fluid cooler tube to unlock the latch.

  1. Install the transmission fluid cooler tubes. Connect the transmission fluid cooler tubes to the transaxle and the transmission fluid cooler until they bottom out and slide the latches to the locked position.
    • Pull back on each connector to confirm that it is locked on the transaxle or the transmission fluid cooler.

  1. Install the 4 transmission fluid cooler tube secondary latches.

  1. Install the ACL . For additional information, refer to Section  303-12.
  1. Check the transmission fluid and fill if necessary.
Transmission Fluid Cooler
NOTE: The transmission fluid cooler is part of the A/C condenser assembly and cannot be serviced separately. If installation of a new transmission fluid cooler is required, install a new c ...

Shifter Input and Linkage
...

More about Ford Focus:

Ford Focus Timing Drive Components
Removal NOTICE: Do not loosen or remove the crankshaft pulley bolt without first installing the special tools as instructed in this procedure. The crankshaft pulley and the crankshaft timing sprocket are not keyed to the crankshaft. The crankshaft, the crankshaft sprocket and the pulley are ...

© 2016-2024 Copyright www.ffguide.net