Ford Focus Service Manual: Safety Belt Shoulder Height Adjuster

NOTE:

LH shown, RH similar.

Item	Part Number	Description
1	602B82	Safety belt shoulder height adjuster
2	—	Safety belt height adjuster bolt (part of 602B82)

Removal and Installation

WARNING: After
any crash, all of the following safety belt assemblies and attaching hardware must be inspected to verify correct function:

• Retractors
• Buckles
• Belt tension sensor (BTS) (if equipped)
• Front safety belt buckle support assemblies (slide bar) (if equipped)
• Safety belt shoulder belt height adjusters (if equipped)
• Child safety seat tether bracket assemblies
• Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)

If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing portion of this section, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.

After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the risk of serious personal injury or death in a crash.

1. Remove the B-pillar trim panel(s). For additional information, refer to B-Pillar Trim Panel — 2-Door or B-Pillar Trim Panel — 4-Door in Section  501-05.

1. Lower the safety belt shoulder height adjuster and remove the bolt.
   • To install, tighten to 40 Nm (30 lb-ft).

1. Remove the safety belt shoulder height adjuster.
   1. Rotate the safety belt shoulder height adjuster downward to release the lower tab.
   1. Remove the safety belt shoulder height adjuster.

1. NOTE:

   Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

   To install, reverse the removal procedure.

1. Check the active restraint system for correct operation. For additional information, refer to Safety Belt System in this section.