Ford Focus Service Manual: Roof Opening Panel Weatherstrip
Removal
- Remove the roof opening panel glass. For additional information, refer to Roof Opening Panel Glass in this section.
- Remove the roof opening panel glass weatherstrip.
Installation
- Place a new weatherstrip into position on the glass assembly, with the splice (seam) on the passenger side.
- Starting with the corners, push the weatherstrip into position. Continue pushing the weatherstrip into position around the glass assembly until complete. Use a plastic hammer if necessary.
- Install the roof opening panel glass. For additional information, refer
to Roof Opening Panel Glass in this section.
- Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization in this section.
Fender Splash Shield
Removal and Installation
With the vehicle in NEUTRAL, position it on a hoist. For additional information,
refer to Section 100-02.
Remove the 10 fender splash shield pin-type reta ...
More about Ford Focus:
Ford Focus Cylinder Bore Taper
NOTE: Refer to the appropriate Section 303-01 for the specification.
Measure the cylinder bore at the top, middle and bottom of piston ring travel
in 2 directions as indicated. Verify the cylinder bore is within the wear limit.
The difference indicates the cylinder bore taper. If the cyl ...
© 2016-2025 Copyright www.ffguide.net
