Ford Focus Service Manual: Reverse Clutch

Ford Focus Service Manual / Powertrain / Transmission/Transaxle / Automatic / Transmission Unit / Reverse Clutch

Special Tool(s)

Compressor, Clutch Spring 307-015 (T65L-77515-A)

Material

Item	Specification
Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLVC (US); CXT-10-LV12 (Canada)	MERCON® LV

Item	Part Number	Description
1	7D483	Retaining ring
2	7B066	Pressure plate
3	7B442	Steel plates
4	7B164	Friction plate assembly
5	7H075	Spring retainer ring
6	7D406	Spring retainer
7	7B070	Piston return spring
8	7B402	Piston assembly
9	7D044	Intermediate and Overdrive (O/D) drum assembly

Disassembly

Remove the reverse clutch pressure, friction and steel plates.
1. Remove the retaining ring.
1. Remove the plates.

Using the Clutch Spring Compressor, remove the reverse clutch piston return spring retainer ring and retainer.

Remove the reverse clutch piston return spring.

Remove the reverse clutch piston assembly.

NOTICE: If damage is found to the reverse clutch piston seals, install a new reverse clutch piston.

Inspect the seal bore in drum, inner and outer seals.

Assembly

Soak the internal spline clutch plates in clean transmission fluid.

Lubricate and install the reverse clutch piston assembly.

Install the reverse clutch piston return spring.

Using the Clutch Spring Compressor, install the reverse clutch piston return spring retainer and retainer ring.

Install the reverse clutch pressure, friction and steel plates.
1. Install the plates.
1. Install the retaining ring.
- Check the clearance. For additional information, refer to Specifications in this section.

Forward Clutch

Special Tool(s) Compressor, Spring Washer 307-209 Dial Indicator Gauge With Holding Fixture 100-002 (TOOL-4201-C) Material Item ...

Turbine Shaft Speed (TSS) Sensor

Material Item Specification Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLVC (US); CXT-10-LV12 (Canada) MERCON® LV Thread Sealant with PTFE ...

More about Ford Focus:

Ford Focus Selector Lever Cable Adjustment
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02. Move the selector lever to the DRIVE position. Disconnect the selector lever cable end from the manual control lever. Unlock the selector lever c ...