Ford Focus manuals

Ford Focus Service Manual: Powertrain Control Module (PCM)


 
Item Part Number Description
1 14A464 PCM electrical connector (3 required)
2 W505423 PCM bolt (2 required)
3 12A650 PCM

Removal

  1. NOTE:

    PCM installation DOES NOT require new keys or programming of keys, only a Parameter Reset of the Passive Anti-Theft System (PATS) .

    Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to Section  418-01.

  1. Remove the Air Cleaner (ACL) outlet pipe and the ACL assembly. For additional information, refer to Section  303-12.
  1. Disconnect the 3 PCM electrical connectors.
  1. Remove the 2 bolts and the PCM.

Installation

  1. Install the PCM and the 2 bolts.
    • Tighten to 8 Nm (71 lb-in).
  1. Connect the 3 PCM electrical connectors.
  1. Install the ACL outlet pipe and the air cleaner assembly. For additional information, refer to Section  303-12.
  1. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to Section  418-01.
  1. Reprogram the PATS . Carry out the Parameter Reset procedure. For additional information, refer to Section  419-01B.
Module Controlled Functions
Smart Junction Box (SJB) The SJB is located under the instrument panel on the driver side (left of the steering column) has control of the following systems: Interior lighting Exterior lig ...

Transmission Control
...

More about Ford Focus:

Ford Focus Vehicle Certification Label
Base Engine Calibration Information Base engine calibration information, sometimes referred to as the powertrain calibration, is located in the lower right corner of the vehicle certification label. Engine calibration information is limited to a maximum of 5 characters per line (2 lines maxim ...

© 2016-2025 Copyright www.ffguide.net