Ford Focus Service Manual: Mode Door Actuator - Air Inlet Door
Item |
Part Number |
Description |
1 |
— |
Air inlet mode door actuator electrical connector (part of 18B604)
|
2 |
— |
Air inlet mode door actuator screw (2 required) |
3 |
19E616 |
Air inlet mode door actuator (2-pin) |
Removal and Installation
- Remove the blower motor resistor. For additional information, refer to Blower
Motor Resistor in this section.
- Remove the 2 air inlet mode door actuator screws.
- Disconnect the air inlet mode door actuator electrical connector.
- Remove the air inlet mode door actuator.
- To install, reverse the removal procedure.
Item
Part Number
Description
1
—
Temperature blend door actuator electrical connector (part of 18B604)
2
—
Temperature blend door actua ...
Item
Part Number
Description
1
—
Defrost/panel/floor mode door actuator electrical connector (part of
18B604)
2
—
Defrost/panel/floor ...
More about Ford Focus:
Ford Focus Power steering fluid check
Vehicles with 1.4L Duratec-16V (Sigma) or 1.6L Duratec-16V (Sigma) or 1.6L
Duratec-16V Ti- VCT (Sigma) engine
The fluid level should come up to the
MAX mark when the engine is cold.
If it drops below the MIN mark, top up
with the specified fluid. See Technical
specifications.
All except ve ...