Ford Focus manuals

Ford Focus Service Manual: Halfshaft Seal - LH (Manual Transaxle/Transmission — MTX75)

Ford Focus Service Manual / Powertrain / Driveline / Driveline Seals / Halfshaft Seal - LH (Manual Transaxle/Transmission — MTX75)

Special Tool(s)

Installer, Halfshaft Oil Seal 308-039

Remover, Halfshaft Oil Seal 307-163 (T86P-70043-A)

Remover, Pilot Bearing 308-001 (T58L-101-B)

Material
Item Specification
Motorcraft® Full Synthetic Manual Transmission Fluid XT-M5-QS WSD-M2C200-C


 
Item Part Number Description
1 3K169 Halfshaft seal
2 7003 Transaxle

Removal

  1. Remove the LH halfshaft. For additional information, refer to Section  205-04.
  1. Using the Pilot Bearing Remover with the Halfshaft Oil Seal Remover, remove and discard the halfshaft oil seal.

Installation

  1. Using the Halfshaft Oil Seal Installer, install the new halfshaft oil seal.

  1. Install the halfshaft. For additional information, refer to Section  205-04.
  1. NOTE:

    The fill height is 0.0-0.5 mm (0.0-0.2 in) below the lower edge of the filler hole.

    Remove the transaxle fluid filler plug. Check the transaxle fluid level and fill with manual transmission fluid as necessary.

    • Tighten to 35 Nm (26 lb-ft).

Driveline Seals
...

Halfshaft Seal - LH (Automatic Transaxle/Transmission — 4F27E)
Special Tool(s) Handle 205-153 (T80T-4000-W) Installer, Axle Oil Seal 205-259 (T87P-3254-A) Material Item Specification ...

More about Ford Focus:

Ford Focus Cylinder Bore Taper
NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the cylinder bore at the top, middle and bottom of piston ring travel in 2 directions as indicated. Verify the cylinder bore is within the wear limit. The difference indicates the cylinder bore taper. If the cyl ...

© 2016-2025 Copyright www.ffguide.net