Ford Focus Service Manual: Evaporative Emission Canister
| Item | Part Number | Description |
|---|---|---|
| 1 | — | Vapor tube-to-Evaporative Emission (EVAP) canister quick connect coupling (part of 9C047) |
| 2 | 9E857 | EVAP canister |
| 3 | W707142 | EVAP canister nut (3 required) |
| 4 | — | Fuel vapor tube assembly-to-EVAP canister quick connect coupling (part of 9K164) |
| 5 | — | Fresh air hose (part of 9034) |
| 6 | 9F945 | EVAP canister vent solenoid |
| 7 | 14A464 | EVAP canister vent solenoid electrical connector |
Removal and Installation
WARNING: Do not
smoke, carry lighted tobacco or have an open flame of any type when working on or
near any fuel-related component. Highly flammable mixtures are always present and
may be ignited. Failure to follow these instructions may result in serious personal
injury.
WARNING: Do not
carry personal electronic devices such as cell phones, pagers or audio equipment
of any type when working on or near any fuel-related component. Highly flammable
mixtures are always present and may be ignited. Failure to follow these instructions
may result in serious personal injury.
WARNING: Always
disconnect the battery ground cable at the battery when working on an evaporative
emission (EVAP) system or fuel-related component. Highly flammable mixtures are
always present and may be ignited. Failure to follow these instructions may result
in serious personal injury.
NOTE:
The Evaporative Emission (EVAP) canister on a Partial Zero Emissions Vehicle (PZEV) is similar in appearance, but unique in design and is not interchangeable with a non-PZEV canister.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
- Disconnect the battery ground cable. For additional information, refer to Section 414-01.
- NOTE:
Clean the EVAP canister vent solenoid electrical connector and the immediate surrounding area of any dirt or foreign material.
Disconnect the EVAP canister vent solenoid electrical connector.
- Disconnect the vapor tube-to-EVAP canister quick connect coupling. For additional information, refer to Section 310-00.
- Disconnect the fuel vapor tube assembly-to-EVAP canister quick connect coupling. For additional information, refer to Section 310-00.
- Disconnect the fresh air hose from the EVAP canister.
- Remove the 3 nuts and the EVAP canister.
- To install, tighten to 4 Nm (35 lb-in).
- To install, reverse the removal procedure.
- Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test in this section.
Fuel Vapor Tube Assembly
Item
Part Number
Description
1
9034
Fuel tank filler pipe
2
W709393
Fuel tank filler pipe bracket bolt
3
—
Fuel tank filler ...
Evaporative Emission Canister Purge Valve
Item
Part Number
Description
1
9G683
Evaporative Emission (EVAP) canister purge valve bracket
2
9G641
EVAP canister purge valve
3
...
More about Ford Focus:
Ford Focus Door Glass Top Run - Rear
Material
Item
Specification
Seam Sealer
TA-2
—
Removal and Installation
Remove the rear door speaker. For additional information, refer to Section
415-00.
NOTE: Do not touch the adhesive surface during removal or installation
of the wat ...
