Ford Focus Service Manual: Cooling Fan Motor and Shroud
Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
- Remove the lower radiator air deflector. For additional information, refer to Section 501-02.
- Disconnect the cooling fan motor and shroud electrical connector and the pin-type retainers.
- Remove the 2 bolts and remove the cooling fan motor and shroud from the
vehicle.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
Radiator
With the vehicle in NEUTRAL, position it on a hoist. For additional information,
refer to Section 100-02.
Drain the cooling system. For additional information, refer to Cooling Syst ...
Emissions
...
More about Ford Focus:
Ford Focus Cylinder Bore Taper
NOTE: Refer to the appropriate Section 303-01 for the specification.
Measure the cylinder bore at the top, middle and bottom of piston ring travel
in 2 directions as indicated. Verify the cylinder bore is within the wear limit.
The difference indicates the cylinder bore taper. If the cyl ...
© 2016-2024 Copyright www.ffguide.net
