Ford Focus Service Manual: Connecting Rod Bushing Diameter

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Connecting Rod Bushing Diameter

NOTE:

Refer to the appropriate Section 303-01 for the specification.

Use a telescoping gauge to determine the ID of the connecting rod bushing, if equipped.

Measure the telescoping gauge with a micrometer. Verify the diameter is within specification.

Connecting Rod Bend

Special Tool(s) Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent NOTE: Refer to the appropriate Section 303-01 for the specification. Using the Feeler Gauge ...

Connecting Rod Cleaning

NOTICE: Do not use a caustic cleaning solution or damage to connecting rods can occur. NOTE: The connecting rod large end is a matched set. The connecting rod cap must be installed on the or ...

More about Ford Focus:

Ford Focus Bearing Inspection - Engine System
Inspect bearings for the following defects: Cratering — fatigue failure Spot polishing — incorrect seating Imbedded dirty engine oil Scratching — dirty engine oil Base exposed — poor lubrication Both edges worn — journal damaged ...